OMRON
Home >> Products >> OMRON >> Control equipments >> Counter >> Total time counter >> H7EC-NP | OMRON PCB-mounting Counters H7EC-NP

H7EC-NP | OMRON PCB-mounting Counters H7EC-NP

OMRON H7EC-NP Manual And Instructions
H7EC-NP datasheetPDF datasheet
H7EC-NP Communications Manual

OMRON H7EC-NP Product information and technical parameters:
Brand: OMRON
Name: PCB-mounting Counters
Model: H7EC-NP
Count input: No-voltage input.
Display: 7-segment LCD.
Total counter: Max. counting speed; 1 kHz.
Dedicated for use on PCB.
Total Counters and Time Counter available.

Input type: PNP input type.
Event input terminal 5 points (HOLD, RESET) equipped with.
External power supply DC12V80mA.
Note: K3HB-RPB-A, K3HB-RNB-A is not equipped with event input.
Relay contact: HH; PASS1c, H, L, LL: each 1a.
96 (W) * 48 (H * 95mm) depth.
Power supply voltage: AC100 ~ 240V.
Measurement of 2 points through the speed, time, or cycle of the digital time interval table OMRON H7EC-NP H7EC-NP
Action determine the color, can switch the green / Red 2 kinds of color display.
Measurement of wide range of pulse interval time.
Measuring, calculating and displaying the pulse interval between 2 points.
Pulse interval measurement range, the maximum can be measured from 10ms to 32Sunshine control time switch OMRON H7EC-NP.
Rotary device with a display unit, which is always capable of reading from the front.
Accord with JIS protocol size.
There is no need to adjust the time of sunrise and sunset in support of daylight saving time when the seasons change.
5 modes of operation. (4 kinds of Sunshine Action)
With automatic reset function, to prevent misuse. Supply voltage: 24 to 240 VAC/DC.
Control output: Contact output, DPDT (time-limit DPDT,
or time-limit SPDT + instantaneous SPDT)Changed using a switch OMRON H7EC-NP.
Eight-mode Timer.
Multiple time ranges and operating modes let you cover a wide,
range of applications.
The time-limit DPDT output contacts can be changed to time-limit,
SPDT and instantaneous SPDT output contacts using a switch.
Sequence checks are easily performed by setting an instanta,
neous output to 0.
Start signal control for the H3DK-M. Input type: NPN/ voltage pulse input type.
Event input terminal 5 points (HOLD, RESET, COMPENSATION) is equipped with.
External power supply DC12V80mA.
Communication: RS-232C; NPN open collector (OUT5, OUTT4, OUT3, OUT2, OUT1) H7EC-NP.
96 (W) * 48 (H * 95mm) depth.
Power supply voltage: AC100 ~ 240V.
High speed pulse.
Measuring, increasing or decreasing pulse meter.
Action determine the color, can switch the green / Red 2 kinds of color display.
The besst choice of rotating encoder and all kinds of ON/OFF pulse signal at high speed,
Cumulative pulse input is 50kHz, the phase difference pulse is 25kHz,


...More relevant models >>>>